GPS Module with 16 Channels
GPS Module with 16 Channels
GPS module AG-G14-MTI-3
Key Specifications/Special Features:
- Build-high performance NEMERIX chipset
- Average Cold Start is in under 45 seconds
- Low power consumption
- 16 channels, all-in-view tracking
- On chip 4Mb flash memory
- TTL level serial ports with one for GPS receiver command message interface, and one for RTCM-104 DGPS input
- Compact board size: MTI-3 1.043 x 1.043 x 0.11inches (26.5 x 26.5 x 3.0mm)
- MTI-3P 1.043 x 1.043 x 0.27 inches (26.5 x 26.5 x 7.0mm) for easy integration into hand-held device
- Reacquisition time: 0.1 second
GPS (Global Position System) is a technique used for position or navigation by receiving and transmitting satellite signals. In order to receive the signals, the antenna is necessary. All GPS satellites broadcast at the same two frequencies, 1575.42 MHz (L1 signal) and 1227.6 MHz (L2 signal), which L1 is for civilian use. The L1 signal is circular polarization, and the strength is around -166DBM, which is weaker signal by comparison with others. These characteristics determine the specifications of the antenna that are used for receiving GPS signals. Our Ceramic Patch Antenna is custom made that meets all characteristics mentioned above, and also has the advantage of small size and a little effect on environmental change of temperature.
GPS is by receiving satellite signals, Terminal for positioning or navigation. And accept the signals to the antenna must be used. Into L1 and L2 GPS satellite signals, frequency and 1575.42MHZ, respectively, where L1 is the opening of civil signals, the signal is circular polarization. Signal strength is about -166DBM, belonging to the weaker signal. These characteristics determined to prepare specifically for the GPS signal receiving antenna. Our CERAMIC PATCH ANTENNA has the advantage of small size, and environmental effects of temperature change on its little.